Inspection Method for Actuators or Relays
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Connect WDS or equivalent to DLC-2.
- Turn the ignition switch to the ON position (Engine off).NOTE:
- If engine starts and runs, perform the following steps while idling engine.
- Prepare the output state control for actuators or relays that you are inspecting.
- Vibrate the actuator or relay with your finger for 3 s
after output state control is activated.
- If variable click sound is heard, check for poor connection and/or poorly mounted actuator or relay.
NOTE:- Vibrating relays too strongly may result in open relays.