LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 492 (On-Board Diagnostic [Engine Control System BP, BP With TC]) >> DTC P1621 >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
DTC P1621 [BP, BP WITH TC] DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or online repair information availability.
  • Is any repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 VERIFY DTC P1621 DETECTED AGAIN 
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Turn ignition key to OFF, then start engine.
  • Is same DTC present?
Yes Perform code word reprogram procedure.
(See IMMOBILIZER SYSTEM REPROGRAM PROCEDURE )
No Go to the next step.
3 VERIFY TROUBLESHOOTING OF DTC P1621 COMPLETED 
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Turn ignition key to OFF, then start engine.
  • Is same DTC present?
Yes Replace PCM, then go to the next step.
No Go to the next step.
4 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection. (See DTC TABLE )
No Troubleshooting completed.