Diagnostic procedure

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0245 [BP With TC] DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Check for related Service Bulletins and/or online repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY CURRENT SIGNAL STATUS: IS CONCERN INTERMITTENT OR CONSTANT? Connect the WDS or equivalent to the DLC-2. Clear the DTC from the PCM memory using the WDS or equivalent. Run the vehicle under the FREEZE FRAME DATA stored condition. Is the same PENDING CODE for this DTC present?	Yes	Go to the next step.
3		No	Intermittent concern exists. Perform the "INTERMITTENT CONCERNS TROUBLESHOOTING". (See INTERMITTENT CONCERN TROUBLESHOOTING .)
4	INSPECT TURBOCHARGER WASTEGATE REGULATING VALVE CONNECTOR FOR POOR CONNECTION Turn the ignition switch off. Disconnect the turbocharger wastegate regulating valve connector. Inspect for poor connection (such as damaged/pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 8.
4		No	Go to the next step.
5	INSPECT TURBOCHARGER WASTEGATE REGULATING VALVE CONTROL CIRCUIT FOR SHORT TO GROUND Turn the ignition switch to off. Inspect continuity between the turbocharger wastegate regulating valve terminal A and body ground. Is there continuity?	Yes	Repair or replace the wiring harness for a possible short to ground, then go to Step 8.
5		No	Go to the next step.
6	INSPECT TURBOCHARGER WASTEGATE REGULATING VALVE Inspect the turbocharger wastegate regulating valve. (See TURBOCHARGER WASTEGATE REGULATING VALVE INSPECTION [BP WITH TC] .) Is there any malfunction?	Yes	Replace the turbocharger wastegate regulating valve, then go to Step 8. (See VACUUM HOSE ROUTING DIAGRAM [BP WITH TC] .)
6		No	Go to the next step.
7	INSPECT PCM CONNECTOR FOR POOR CONNECTION Turn the ignition switch off. Disconnect the PCM connector. Inspect for poor connection (such as damaged/pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair or replace the terminal, then go to the next step.
7		No	Go to the next step.
8	VERIFY TROUBLESHOOTING OF DTC P0245 COMPLETED Make sure to reconnect all disconnected connectors. Clear the DTC from the PCM memory using the WDS or equivalent. Start the engine. Is the PENDING CODE for this DTC present?	Yes	Replace the PCM, then go to the next step.
8		No	Go to the next step.
9	VERIFY AFTER REPAIR PROCEDURE Perform the "AFTER REPAIR PROCEDURE ". (See AFTER REPAIR PROCEDURE .) Is any DTC present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE .)
9		No	Troubleshooting completed.