LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 487 (Washer System & Wiper System) >> Headlight Cleaner Hose Removal/Installation

Headlight Cleaner Hose Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the front side marker light. (See FRONT SIDE MARKER LIGHT REMOVAL/INSTALLATION .)
  3. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION .)
  4. Disconnect joint pipe.
  5. Disconnect headlight cleaner hose from the headlight cleaner actuator.
  6. Remove the headlight cleaner hose from the front bumper.
  7. Install in the reverse order of removal.
    Fig 1: Removing Headlight Cleaner Hose From Front Bumper
    G03703363Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals