LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 485 (Interior Trim) >> Tire House Trim Removal/Installation

Tire House Trim Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat. (See REAR SEAT REMOVAL/INSTALLATION .)
  2. Remove the inner scuff plate. (See INNER SCUFF PLATE REMOVAL/INSTALLATION .)
  3. Partially peel back the seaming welt.
  4. Pull the tire house trim outward and detach clips A and locator pins B.
  5. Detach tabs C and remove the tire house trim.
  6. Install in the reverse order of removal.
    Fig 1: Removing Tire House Trim
    G03703252Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals