LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Seats) >> Seat Warmer Inspection >> Seat Cushion

Seat Cushion

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION .)
  2. Remove the seat cushion trim. (See FRONT SEAT DISASSEMBLY/ASSEMBLY .)
  3. While inspecting for continuity between the terminals A and B of the connector, use a dryer to warm the thermostat of the seat warmer unit on seat cushion.
    Fig 1: Using A Dryer To Warm Thermostat Of Seat Warmer Unit On Seat Cushion
    G03703125Courtesy of MAZDA MOTORS CORP.
  4. Verify that the continuity between the seat warmer terminals is as indicated in the table.
    • If not as indicated in the table, replace the seat warmer unit.
    Fig 2: Connector Terminal Continuity Reference Chart
    G03703126Courtesy of MAZDA MOTORS CORP.
    Fig 3: Measuring Continuity Between Seat Warmer Terminals
    G03703127Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals