Front Buckle Switch Inspection: Passenger-Side

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Disconnect the buckle switch connector.
Verify continuity as indicated in the table.
- If not as indicated in the table, replace the front buckle.
Fig 1: Passenger Side (Front Buckle Switch) Continuity Chart
Courtesy of MAZDA MOTORS CORP.

Fig 2: Inspecting Passenger Side (Front Buckle Switch) Continuity
Courtesy of MAZDA MOTORS CORP.