LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 474 (Air Bag System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures >> Deployment Procedure for Inside of Vehicle >> Side air bag module

Side air bag module

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the side air bag module connector.
  2. Connect the SST  (Adapter harness) to the side air bag module as shown in the figure.
    Fig 1: Connecting SST (Adapter Harness) To Side Air Bag Module
    G03702893Courtesy of MAZDA MOTORS CORP.
  3. Connect the SST  (Deployment tool) to the SST  (Adapter harness).
  4. Connect the SST  (Deployment tool) to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the negative battery terminal.
  5. Verify that the red lamp on the SST  (Deployment tool) is illuminated.
  6. Verify that all persons are standing at least 6 m {20 ft}  away from the vehicle.
    Fig 2: Connecting SSTs (Deployment Tool) To SSTs (Adapter Harness)
    G03702894Courtesy of MAZDA MOTORS CORP.
  7. Press the activation switch on the SST  (Deployment tool) to operate (deploy) the side air bag module.
    Fig 3: Identifying Activation Switch On SST (Deployment Tool)
    G03702895Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals