LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 473 (On-Board Diagnostic (Air Bag System)) >> PID/Data Monitor Table

PID/Data Monitor Table

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
PID/DATA MONITOR REFERENCE

PID name (definition) Unit/Condition Operation Condition (Reference) Terminal
CCNT_RCM (Number of continuous DTCs) -
  • DTCs detected: 1-255
  • No DTCs detected: 0
-
D_ABAGR2 (Driver-side air bag module (inflator No.2) resistance) Ohms Under any condition: 1.5-3.7 ohms 1G, 1J
D_CRSHS (Driver-side side air bag sensor status) OK/COMM_FAIL/INT_FAIL
  • Sensor normal: OK
  • Sensor communication error: COMM_FAIL
  • Sensor internal circuit abnormal: INT_FAIL
2Z, 2AA
DABAGR (Driver-side air bag module (inflator No.1) resistance) Ohms Under any condition: 1.5-3.7 ohms 1S.1V
D_PTENSFLT (Driver-side pre-tensioner seat belt circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Pre-tensioner seat belt circuit resistance low: SQ_LOWRES
2P, 2S
DR_BUKL (Driver-side buckle switch status) Buckled/Unbuckled
  • Driver-side buckle switch on: Buckled
  • Driver-side buckle switch off: Unbuckled
2T
DR_CURTN (Driver-side curtain air bag module resistance) Ohms Under any condition: 1.4-3.2 ohms 2V, 2Y
DR_PTENS (Driver-side pre-tensioner seat belt resistance) Ohms Under any condition: 1.5-3.1 ohms 2P, 2S
DS_AB (Driver-side side air bag module resistance) Ohms Under any condition: 1.4-3.2 ohms 2M, 2O
DS_AB_ST (Driver-side side air bag module circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
2M, 2O
DS_CURT_ST (Driver-side curtain air bag module circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
2V, 2Y
DS1_STAT (Driver-side air bag module (inflator No.1) circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
1S, 1V
DS2_STAT (Driver-side air bag module (inflator No.2) circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
1G, 1J
DSB_P_ST (Driver-side pre-tensioner seat belt circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Pre-tensioner seat belt circuit resistance low: SQ_LOWRES
2P, 2S
FNT_CRSH_S (Crash zone sensor status) OK/COMM_FAIL/INT_FAIL
  • Sensor normal: OK
  • Sensor communication error: COMM_FAIL
  • Sensor internal circuit abnormal: INT_FAIL
1B, 1C
OD_D_CRSH (Driver-side side air bag sensor status) OK/COMM_FAIL/INT_FAIL
  • Sensor normal: OK
  • Sensor communication error: COMM_FAIL
  • Sensor internal circuit abnormal: INT_FAIL
2Z, 2AA
OD_D_CURT (Driver-side curtain air bag module circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
2V, 2Y
OD_DAB1_ST (Driver-side air bag module (inflator No.1) circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
1S, 1V
OD_DAB2_ST (Driver-side air bag module (inflator No.2) circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
1G, 1J
OD_DSAB_ST (Driver-side side air bag module circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
2M, 2O
OD_F_CRSH (Crash zone sensor status) OK/COMM_FAIL/INT_FAIL
  • Sensor normal: OK
  • Sensor communication error: COMM_FAIL
  • Sensor internal circuit abnormal: INT_FAIL
1B, 1C
OD_P_CRSH (Passenger-side side air bag sensor status) OK/COMM_FAIL/INT_FAIL
  • Sensor normal: OK
  • Sensor communication error: COMM_FAIL
  • Sensor internal circuit abnormal: INT_FAIL
2B, 2C
OD_P_CURT (Passenger-side curtain air bag module circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
2A, 2D
OD_PAB1_ST (Passenger-side air bag module (inflator No.1) circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
1M, 1P
OD_PAB2_ST (Passenger-side air bag module (inflator No.2) circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
1A, 1D
OD_PSAB_ST (Passenger-side side air bag module circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
2I, 2L
P_ABAGR2 (Passenger-side air bag module (inflator No.2) resistance) Ohms Under any condition: 1.4-2.9 ohms 1A, 1D
P_PTENSFLT (Passenger-side pre-tensioner seat belt circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Pre-tensioner seat belt circuit resistance low: SQ_LOWRES
2G, 2J
PABAGR (Passenger-side air bag module (inflator No.1) resistance) Ohms Under any condition: 1.4-2.9 ohms 1M, 1P
P_CRSH_S (Passenger-side side air bag sensor status) OK/COMM_FAIL/INT_FAIL
  • Sensor normal: OK
  • Sensor communication error: COMM_FAIL
  • Sensor internal circuit abnormal: INT_FAIL
2B, 2C
PS_AB (Passenger-side side air bag module resistance) Ohms Under any condition: 1.4-3.2 ohms 2I, 2L
PS_AB_ST (Passenger-side side air bag sensor circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
2I, 2L
PS_BUKL (Passenger-side buckle switch status) Buckled/Unbuckled
  • Passenger-side buckle switch on: Buckled
  • Passenger-side buckle switch off: Unbuckled
2H
PS_CURTN (Passenger-side curtain air bag module resistance) Ohms Under any condition: 1.4-3.2 ohms 2A, 2D
PS_CURT_ST (Passenger-side curtain air bag module circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
2A, 2D
PS_PTENS (Passenger-side pre-tensioner seat belt resistance) Ohms Under any condition: 1.5-3.1 ohms 2G, 2J
PS1_STAT (Passenger-side air bag module (inflator No.1) circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
1M, 1P
PS2_STAT (Passenger-side air bag module (inflator No.2) circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Air bag module circuit resistance low: SQ_LOWRES
1A, 1D
PSB_P_ST (Passenger-side pre-tensioner seat belt circuit status) NORMAL/OPEN/SHRT_GND/SHRT_B+/SQ_LOWRES
  • Related wiring harness normal: NORMAL
  • Related wiring harness circuit open: OPEN
  • Related wiring harness short to ground: SHRT_GND
  • Related wiring harness short to power supply: SHRT_B+
  • Pre-tensioner seat belt circuit resistance low: SQ_LOWRES
2G, 2J
RCM_VOLT (IG1 voltage) V
  • Ignition switch is at ON: B+
  • Other: 0
1W
TRAK_SW (Seat track position sensor state) Forward/Rearward
  • Front seat front position: Forward
  • Front seat rear position: Rearward
2W, 2X