LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Air Bag System) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicle) >> Driver-side AIR Bag

Driver-side AIR Bag

WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before deploying air bag, inspect operating condition of Deployment Tool (49 H066 002). See INSPECTING DEPLOYMENT TOOL  under DISPOSAL PROCEDURES. Ensure vehicle is outside and away from other vehicles and people. Disable air bag system, See DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Connect Deployment Harness Adapter (49 D066 002) to driver-side air bag clockspring connector. See Figure. Connect deployment tool connector "A" to harness adapter. See Fig 1. Close all doors and windows. Connect Red clip of deployment tool to positive battery terminal and Black clip of deployment tool to negative battery terminal. Verify deployment tool Red light is on.
  3. Ensure all persons are at least 20 feet from vehicle. Press deployment tool activation switch to deploy air bag. Because of heat generated from air bag deployment, wait at least 15 minutes before handling deployed air bag module.
Fig 1: Identifying Air Bag Deployment Tool Connectors
G98A13839Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals