Tie rod Inspection
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect for damage, bending and excessive play.
- If there is any malfunction, replace the steering gear and linkage.
- Swing the ball joint 5 times .
- Measure the swing torque using a pull scale.
- If it exceeds the specification, replace the steering gear and linkage.
Standard swing torque
- 0.68-2.45 N.m
- {7.0-24.9 kgf.cm, 6.1-21.6 in.lbf}
Pull scale reading
- 6.8-24.5 N {0.70-2.49 kgf, 1.53-5.50 lbf}