LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Automatic Transmission [Shift Mechanism]) >> Selector Lever Component Inspection

Selector Lever Component Inspection

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine cover.
  2. Remove the battery cover.
  3. Disconnect the negative battery cable.
  4. Remove the ashtray. (See CONSOLE REMOVAL/INSTALLATION .)
  5. Remove the shift knob. (See SELECTOR LEVER REMOVAL/INSTALLATION .)
  6. Remove the console panel and indicator assembly. (See SELECTOR LEVER REMOVAL/INSTALLATION .)
  7. Disconnect the selector lever component connector.
  8. Verify continuity as indicated in the table.
    Fig 1: Identifying Continuity Between Connector Terminals
    G03702706Courtesy of MAZDA MOTORS CORP.
    Fig 2: Connector Terminal - Lever Position Specification Table
    G03702707Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals