LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 465 (Automatic Transmission [Service, Removal & Installation)) >> Automatic Transmission Removal/Installation >> Manual Shaft Lever Component Installation Note

Manual Shaft Lever Component Installation Note

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the mark of the manual shaft lever component as shown in the figure.
  2. Install the manual shaft lever component installation nut.

    Tightening torque 

    1. 10.8-14.7 N.m 
      1. {1.1-1.4 kgf.m, 8.0-10.8 ft.lbf} 
    Fig 1: Aligning Mark Of Manual Shaft Lever Component
    G03702663Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals