No.3 Vehicle Does Not Move In D And M Ranges: Notes

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

VEHICLE DOES NOT MOVE IN D AND M RANGES DESCRIPTION AND POSSIBLE CAUSE

3	Vehicle does not move in D and M ranges
DESCRIPTION	Vehicle does not move in D and M ranges. Vehicle moves in R position.
POSSIBLE CAUSE	Clutch slippage (low clutch, low one-way clutch, low and reverse brake). In the event of clutch slippage, a DTC (incorrect gear ratio) is output. Shift solenoid A or related circuit malfunction Shift solenoid A hydraulic circuit clogging Control valve body malfunction (improper operation, stuck, clogged oil passage). NOTE: Before following the troubleshooting steps, make sure that the Automatic Transmission On-Board Diagnostic and Automatic Transmission Basic Inspection are conducted. (See BASIC INSPECTION .)

Vehicle does not move in D and M ranges

DESCRIPTION

Vehicle does not move in D and M ranges.
Vehicle moves in R position.

POSSIBLE CAUSE

Clutch slippage (low clutch, low one-way clutch, low and reverse brake).
- In the event of clutch slippage, a DTC (incorrect gear ratio) is output.
Shift solenoid A or related circuit malfunction
Shift solenoid A hydraulic circuit clogging
Control valve body malfunction (improper operation, stuck, clogged oil passage).
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transmission On-Board Diagnostic and Automatic Transmission Basic Inspection are conducted. (See BASIC INSPECTION .)