No.26 Engine Stalls When Shifted To D Range, Or In R Position: Notes

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

ENGINE STALLS WHEN SHIFTED TO D RANGE, OR IN R POSITION DESCRIPTION AND POSSIBLE CAUSE

26	Engine stalls when shifted to D range, or in R position
DESCRIPTION	Engine stalls when shifting from N or P position to D range or R position at idle.
POSSIBLE CAUSE	Idle speed is not within specification. Improper idle increase Insufficient engine output Oil cooler malfunction (Foreign material mixed in with ATF) ATF level is low. TCC solenoid malfunction TCC piston malfunction (improper operation, clogged oil passage) NOTE: Before following the troubleshooting steps, make sure that the Automatic Transmission On-Board Diagnostic and Automatic Transmission Basic Inspection are conducted. (See BASIC INSPECTION .)

Engine stalls when shifted to D range, or in R position

DESCRIPTION

Engine stalls when shifting from N or P position to D range or R position at idle.

POSSIBLE CAUSE

Idle speed is not within specification.
Improper idle increase
Insufficient engine output
Oil cooler malfunction (Foreign material mixed in with ATF)
ATF level is low.
TCC solenoid malfunction
TCC piston malfunction (improper operation, clogged oil passage)
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transmission On-Board Diagnostic and Automatic Transmission Basic Inspection are conducted. (See BASIC INSPECTION .)