No.2 Vehicle Does Not Move In R Position: Notes
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
VEHICLE DOES NOT MOVE IN R POSITION DESCRIPTION AND POSSIBLE CAUSE
| 2 |
Vehicle does not move in R position |
| DESCRIPTION |
- Vehicle does not move in R position only.
- Vehicle moves in D and M ranges.
|
| POSSIBLE CAUSE |
- Clutch slippage (low clutch, low one-way clutch, low and reverse brake).
- In the event of clutch slippage, a DTC (incorrect gear ratio) is output.
- Improper adjustment of TR switch
- Open or short circuit in TR switch
- Shift solenoid F or related circuit malfunction
- Shift solenoid F solenoid hydraulic circuit clogging
- Control valve body malfunction (improper operation, stuck, clogged oil passage)
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transmission On-Board Diagnostic and Automatic Transmission Basic Inspection are conducted. (See
BASIC INSPECTION .)
|