No.10 Does Not Shift To 4GR: Notes
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
DOES NOT SHIFT TO 4GR DESCRIPTION AND POSSIBLE CAUSE
| 10 |
Does not shift to 4GR |
| DESCRIPTION |
- Vehicle does not upshift from 3GR to 4GR even though vehicle speed is increased.
- Vehicle does not shift to 4GR even though accelerator pedal is released in D range at 60 km/h {37 mph}.
|
| POSSIBLE CAUSE |
- Oil temperature of TFT sensor is low (4GR is inhibited when temperature is 5 °C {41 °F} or below.
)
- Improper adjustment of TR switch
- Control valve body malfunction (improper operation, stuck, clogged oil passage)
- Hydraulic circuit clogging (shift solenoid A)
- Control valve spool malfunction
- TFT sensor malfunction
- Short or open circuit in wiring
- Poor connection of connector
- Sensor malfunction
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transmission On-Board Diagnostic and Automatic Transmission Basic Inspection are conducted. (See
BASIC INSPECTION .)
|