No.1 Vehicle Does Not Move In D Range, Or In R Position: Notes
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
VEHICLE DOES NOT MOVE IN D RANGE, OR IN R POSITION DESCRIPTION AND POSSIBLE CAUSE
| 1 |
Vehicle does not move in D range, or in R position |
| DESCRIPTION |
- Vehicle does not move when accelerator pedal is depressed.
|
| POSSIBLE CAUSE |
- Clutch slippage (low clutch, low one-way clutch, low and reverse brake).
- In the event of clutch slippage, a DTC (incorrect gear ratio) is output.
- Insufficient or improper ATF
- Reduced line pressure
- Control valve body malfunction (improper operation, stuck, clogged oil passage)
- Insufficient torque
- Torque converter malfunction (improper operation, stuck), insufficient engine output
- Improper operation of parking device
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transmission On-Board Diagnostic and Automatic Transmission Basic Inspection are conducted. (See
BASIC INSPECTION .)
|