Disc Plate Thickness Inspection
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Excessive runout may result if the disc plate is removed from the vehicle then machined. Machine the disc plate while installed on the vehicle.
- Measure the thickness of the disc plate.
- If the thickness is not within the specification, replace the disc plate.
Minimum
- 22 mm {0.87 in}
Minimum thickness after machining using a brake lathe on-vehicle
- 22.8 mm {0.90 in}