Lateral runout inspection
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- To secure the disc plate and the hub, insert the washer (thickness 10 mm {0.39 in},
inner diameter more than 12 mm {0.47 in})
between each hub bolt and the hub nut, then tighten all the hub nuts.NOTE:
- The component parts of the SST (49 B017 001 or 49 G019 003) can be used as a suitable washer.
- After tightening all the hub nuts to the same torque, put the dial gauge on the friction surface of disc plate 10 mm {0.12-0.28 in} from the disc plate edge.
- Rotate the disc plate one time and measure the runout.
Runout limit
- 0.05 mm {0.002 in}