LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 454 (Drive Shaft) >> Rear Drive Shaft Removal/Installation >> Clip Installation Note

Clip Installation Note

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Point the opening of the new drive shaft clip upward, install it to the clip groove at the end of the rear drive shaft with the installation width within the specification.

    Standard 

    1. 32 mm {1.3 in} 
    Fig 1: Identifying Drive Shaft Clip Opening
    G03702263Courtesy of MAZDA MOTORS CORP.
  2. After installing the clip, measure the outer diameter. If it exceeds the specification, reinstall the new clip.
scientia non olet · About LEMON Manuals