LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 454 (Drive Shaft) >> Rear Drive Shaft Disassembly/Assembly >> Tripod Joint, Snap Ring Assembly Note

Tripod Joint, Snap Ring Assembly Note

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the tripod joint with the shaft mark and insert it using a brass bar.
    CAUTION:
    • To prevent damage to the component, do not tap the roller part when installing.
  2. Install the new snap ring to the shaft installation slot securely using a snap ring pliers.
    Fig 1: Aligning Tripod Joint With Shaft Mark And Insert It Using A Brass Bar
    G03702271Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals