Dust Cover Removal Note

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Remove the dust cover only if there is an abnormality.

Place an alignment mark on the dust cover and rear knuckle for proper installation.

Fig 1: Placing Alignment Mark On Dust Cover And Rear Knuckle
Courtesy of MAZDA MOTORS CORP.
Remove the dust cover using a chisel.

Fig 2: Removing Dust Cover Using Chisel
Courtesy of MAZDA MOTORS CORP.