LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 450 (Rear Suspension System) >> Rear Trailing Link (Lower) Removal/Installation >> Rear Trailing Link (Lower) Removal Note

Rear Trailing Link (Lower) Removal Note

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Support the rear knuckle using a jack.
    CAUTION:
    • Be sure that the rear axle component is firmly supported by the jack. If not securely supported, the rear axle component could fall, resulting in serious injury or death, and damage to the vehicle.
  2. Remove the rear trailing link (lower) outer bolt.
  3. Remove the rear trailing link (lower) inner bolt.
    Fig 1: Supporting The Rear Knuckle Using Jack
    G03702194Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals