Passenger-Side Air Bag Module: Installation

WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse removal procedure. Tighten air bag module retaining bolts to specification. See TORQUE SPECIFICATIONS . Remove air bag simulator from passenger-side air bag module harness connector and reconnect connectors. Connect negative battery cable. With air bag simulators installed at all remaining deployable devices, verify system. See VERIFY SYSTEM under DIAGNOSTICS.
Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy. Activate air bag system. See ACTIVATING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Check AIR BAG warning light for proper system function. See SYSTEM OPERATION CHECK .