LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Air Bag System) >> Disabling & Activating Air Bag System >> Disabling System >> For Component Replacement (Driver & Passenger AIR Bags)

For Component Replacement (Driver & Passenger AIR Bags)

WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Record pre-set radio frequencies for reprogramming (if equipped). Disconnect negative battery cable. Also, disconnect any auxiliary batteries and power supplies (if equipped). Wait at least one minute for back-up power supply to deplete stored energy.
  2. Remove hood release handle screws and position handle out of way. Remove lower steering column opening finish panel screws. Pull out on panel to release retaining clips and remove finish panel. Remove lower steering column opening finish panel reinforcement bolts and reinforcement. Disconnect clockspring harness connector at base of steering column. Install Air Bag Simulator (418-F088/105-R0012) to harness side of clockspring connector.
  3. Open glove box door to access passenger-side air bag module connector. Release tab and disconnect air bag electrical connector. Install Air Bag Simulator (418-F088/105-R0012) to harness side of passenger-side air bag module connector.
  4. Connect negative battery cable. With air bag simulators installed at all deployable devices, verify system. See VERIFY SYSTEM  under DIAGNOSTICS. Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy
scientia non olet · About LEMON Manuals