LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 444 (Starting System) >> Starter Inspection >> Magnetic Switch Operation Inspection >> Pull-out test

Pull-out test

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • In case the battery is being charged, the pinion may turn during a protruded state. This is normal because the current flows to the motor through the pull-in coil and the motor turns.
  1. Verify that the drive pinion is pulled out with battery positive voltage connected to terminal S and the starter body grounded.
    • If not pulled out, repair or replace the starter.
    Fig 1: Testing Starter - Pull-Out Test
    G03702017Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals