LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 440 (Exhaust System) >> Exhaust System Removal/Installation >> Engine Mount Bracket (RH) Removal Note >> Engine Mount Rubber (RH) Removal Note

Engine Mount Rubber (RH) Removal Note

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tighten the A part indicated in the figure, and then pull up the engine to remove the engine mount rubber (RH).
    Fig 1: Removing Engine Mount Rubber
    G03701954Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals