Fuel Tank Side (Except for Fuel Shut-off/Rollover Valve): Removal

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Follow the before repair procedure and perform the fuel line safety procedure. (See BEFORE REPAIR PROCEDURE .)
CAUTION:
- The quick release connector may be damaged if the release tab is bent excessively. Do not expand the release tab over the stopper.
NOTE:
- The fuel hose may be removed easily by rotating the release tab while the fuel hose is slightly pressed to fuel pipe side.
Rotate the quick release connector release tab to the stopper position.

Fig 1: Rotating Stopper
Courtesy of MAZDA MOTORS CORP.
Pull out the fuel hose straight from the fuel pipe and disconnect it.

Fig 2: Disconnecting Fuel House
Courtesy of MAZDA MOTORS CORP.
Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from being scratched or contaminated with foreign material.
NOTE:
- Take care not to damage or soil the fuel hose.
Fig 3: Covering Quick Release Connector
Courtesy of MAZDA MOTORS CORP.