LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 435 (Engine Mechanical (Service Information)) >> Engine Tune-Up >> Engine Tune-up Preparation

Engine Tune-up Preparation

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the following:
    • AT: Selector lever is in P or N position.
    • MT: Shift lever is in neutral position.
  2. Turn off all electrical loads (A/C).
  3. Warm up the engine.
    1. Increase the engine speed to 2,500-3,000 RPM  until cooling fans start running.
    2. When the cooling fans start running, release the accelerator pedal and wait until the cooling fans stop running.
  4. Connect the WDS or equivalent to the DLC-2.
  5. Verify that the idling speed (WDS: RPM PID) is within the specification using the WDS or equivalent function.

    Standard 

    1. AT: 760-860 RPM 
    2. MT: 750-850 RPM 
    Fig 1: Identifying Data Link Connector
    G03701811Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals