Diagnostic procedure
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
NO.24 A/C IS ALWAYS ON OR A/C COMPRESSOR RUNS CONTINUOUSLY DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | RESULTS | ACTION |
|---|---|---|---|
| 1 | Connect the WDS or equivalent to the DLC-2. Turn the ignition switch to the ON position (Engine off). Retrieve any DTCs. Are there any DTCs displayed? |
Yes | DTC is displayed: Go to the applicable DTC inspection. (See DTC TABLE .) |
| No | No DTC is displayed: Go to the next step. |
||
| 2 | Start the engine and run it at idle. Turn the A/C switch on. Remove the A/C relay. Does the A/C magnetic clutch disengage? |
Yes | Inspect for the following:
If both items normal, go to the next step. |
| No | Inspect if the circuit between A/C relay and the magnetic clutch shorts to the battery power circuit. If the circuit is normal, inspect the magnetic clutch for stuck engagement or clearance. | ||
| 3 | Disconnect the refrigerant pressure switch connector. Start the engine and turn the A/C switch on.
NOTE:
Does the A/C remain working? |
Yes | Inspect for short to GND circuit between refrigerant pressure switch and PCM terminal 4W. |
| No | Go to the next step. | ||
| 4 | Reconnect refrigerant pressure switch connector. Turn off the A/C switch.
NOTE:
Does the A/C remain working? |
Yes | Inspect the following:
|
| No | Inspect whether the A/C switch is stuck closed. | ||
| 5 |
|
||