LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 427 (Exterior Trim) >> Rear Finisher Removal/Installation

Rear Finisher Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate lock cylinder. (See LIFTGATE LOCK AND OPENER REMOVAL/INSTALLATION .)
  2. Remove the bolts.
  3. Pull the rear finisher toward you, then disengage clip A from the body.
  4. Install in the reverse order of removal.
    Fig 1: Identifying Rear Finisher Removal/Installation Procedure
    G03701301Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals