LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 427 (Exterior Trim) >> Front BELTLINE Molding Removal/Installation

Front BELTLINE Molding Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the screw.
  2. Pull front beltline molding up, then remove it.
  3. Install in the reverse order of removal.
    Fig 1: Front Beltline Molding Removal/Installation Procedure
    G03701306Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals