Rear heat duct No.5
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Fold the third-row seat into rear space.
- Remove the passenger-side rear side trim. (See REAR SIDE TRIM REMOVAL/INSTALLATION .)
- Remove the rear heat duct No.4.
- Remove the rear heater grilles.
- Partially peel off the front floor covering.
- Remove in the order indicated in the table.
- Install in the reverse order of removal.