LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 414 (Automatic Transaxle [Shift Mechanism]) >> Selector Cable Adjustment

Selector Cable Adjustment

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the column cover.
  2. Shift the selector lever to P position.
  3. Loosen nut A shown in the figure.
  4. Pull the selector lever to the R position side gate of P position, and tighten nut A.

    Tightening torque 

    1. 16-22 N.m {1.6-2.3 kgf.m, 12-16 ft.lbf} 
    Fig 1: Identifying Selector Cable Adjustment Nut
    G03700615Courtesy of MAZDA MOTORS CORP.
  5. Verify that the selector lever bolt end is exposed from the nut.
    Fig 2: Verifying That Selector Lever Bolt End Is Exposed From Nut
    G03700616Courtesy of MAZDA MOTORS CORP.
  6. Install the column cover.
scientia non olet · About LEMON Manuals