LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 413 (Automatic Transaxle [Service, Removal & Installation]) >> Road Test >> Shift Schedule Test >> Notes

Shift Schedule Test: Notes

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The NORMAL mode and SLOPE mode are automatically selected by the TCM in D range. The TCM shifts to SLOPE mode when the upgrade is approx. 5% or more, and shifts to NORMAL mode when the upgrade is approx. 3% or less.
  1. Drive the vehicle with wide open throttle, closed throttle position and kickdown, and verify that following shifts are obtained. The shift points must be as shown in the table below.
    • 1GR-->2GR, 2GR-->3GR, 3GR-->4GR, and 4GR--> 5GR upshifts and downshifts are obtained in D range (O/D OFF switch OFF).
    • 1GR-->2GR, 2GR-->3GR, and 3GR-->4GR upshifts and downshifts are obtained in D range (O/D OFF switch ON).
    • 2GR-->3GR upshifts and downshifts are obtained in 3 range.
    • 2GR is held in 2 range.
  2. Decelerate the vehicle under the following conditions, and verify the engine braking effect base on the turbine and engine speeds.
    • 5GR in D range (O/D OFF switch OFF).
    • 4GR in D range (O/D OFF switch ON).
    • 3GR in 3 range.
    • 2GR in 2 range.
  3. Drive the vehicle and verify that TCC operation is obtained in 4GR and 5GR in D range.
    NOTE:
    • The shift solenoid electrical ON-OFF pattern is this chart describes the stabilized condition before and after shift control. The pattern may oscillate between ON and OFF momentarily while shifting-up or down. This is normal.
scientia non olet · About LEMON Manuals