Inspection of Continuity

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the O/D OFF switch connector.
Inspect continuity at the O/D OFF switch.
- If the switch is okay, inspect the wiring harness. (O/D OFF switch-TCM, O/D OFF switch-Body ground)
- If not as specified, replace the selector lever component. (See SELECTOR LEVER REMOVAL/INSTALLATION .)
Fig 1: Terminal Specification Table
Courtesy of MAZDA MOTORS CORP.

Fig 2: Identifying O/D OFF Switch Part Side Connector Terminals
Courtesy of MAZDA MOTORS CORP.