Inspection of Individual Part
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the input/turbine speed sensor. (See INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION .)
- Measure resistance between the terminals of the input/turbine speed sensor.
- If not as specified, replace the input/turbine speed sensor.
- If it is normal, replace the harness.
Courtesy of MAZDA MOTORS CORP.
Resistance (ATF temperature: 20 °C {68 °F}) 513-627 ohms
- Install the input/turbine sensor. (See INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION .)