No.2 Vehicle Moves In N Position: Notes

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

VEHICLE MOVES IN N POSITION - DESCRIPTION AND POSSIBLE CAUSES

2	Vehicle moves in N position
DESCRIPTION	Vehicle creeps in N position. Vehicle creeps if brake pedal not depressed in N position.
POSSIBLE CAUSE	If vehicle moves in N position, basically, malfunction is in ATX. Since a malfunction in sensor circuit or output circuit is cause of malfunction in ATX, inspect sensors, output circuit, and related harnesses. Clutch burned (Low clutch, low one-way clutch, low and reverse brake) Line pressure low Malfunction of control valve body Selector lever position disparity (Although the selector indicator shows N position, hydraulic circuit shows D range or R position) NOTE: Before following troubleshooting steps, make sure that Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.

Vehicle moves in N position

DESCRIPTION

Vehicle creeps in N position.
Vehicle creeps if brake pedal not depressed in N position.

POSSIBLE CAUSE

If vehicle moves in N position, basically, malfunction is in ATX. Since a malfunction in sensor circuit or output circuit is cause of malfunction in ATX, inspect sensors, output circuit, and related harnesses.
- Clutch burned (Low clutch, low one-way clutch, low and reverse brake)
  - Line pressure low
  - Malfunction of control valve body
- Selector lever position disparity (Although the selector indicator shows N position, hydraulic circuit shows D range or R position)
NOTE:
- Before following troubleshooting steps, make sure that Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.