Brake Pedal Play Adjustment
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the spring pin and clevis pin. (See BRAKE PEDAL REMOVAL/INSTALLATION .)
- Loosen locknut Panel turn rod C to align the holes in the fork and in the pedal.
- Install the clevis pin and the spring pin.
- Tighten locknut D.
Tightening torque
- 15.7-21.6 N.m {1.61-2.20 kgf.m, 11.6- 15.9ft.lbf}
- Check the pedal height and the brake light operation,