LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 392 (Engine Mechanical (Service Information)) >> Rear Oil Seal Replacement

Rear Oil Seal Replacement

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION .)
  2. Remove the drive plate. (See DRIVE PLATE REMOVAL/INSTALLATION .)
  3. Cut the oil seal lip using a razor knife.
  4. Remove the rear oil seal using a screwdriver as shown.
    Fig 1: Removing Rear Oil Seal Using A Screwdriver
    G03699791Courtesy of MAZDA MOTORS CORP.
  5. Install the rear oil seal with part A of the SST  [303-178 (49 UN01 070)] and the SST  [303-384 (49 UN30 3384)].
    Fig 2: Identifying SST Components
    G03699792Courtesy of MAZDA MOTORS CORP.
  6. Install the studs of the SST  [303-384 (49 UN30 3384)] as indicated in Fig 3.
    Fig 3: Installing Studs Of SST
    G03699793Courtesy of MAZDA MOTORS CORP.
  7. Apply clean engine oil to the oil seal.
  8. Push the oil seal slightly in by hand.
  9. Install part A of the SST  [303-178 (49 UN01 070)] and compress the oil seal with the nuts of the SST  [303-384 (49 UN30 3384)].
  10. Install the drive plate. (See DRIVE PLATE REMOVAL/INSTALLATION .)
  11. Install the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION .)
    Fig 4: Installing Drive Plate
    G03699794Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals