Windshield Washer Motor Inspection

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION .)
Connect battery positive voltage to the motor terminal A and ground to the motor terminal B.
Verify that the windshield washer motor operates.
- If the motor does not operate, replace the windshield washer motor.
  
  Fig 1: Windshield Washer Motor Circuit Diagram And Connector Terminals
  Courtesy of MAZDA MOTORS CORP.