LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 384 (Exterior Trim) >> Side Step Molding Removal/Installation

Side Step Molding Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rivet.
  2. Pull the side step molding outward, then disengage clips A from the body.
    Fig 1: Locating Clips A
    G03645464Courtesy of MAZDA MOTORS CORP.
  3. Slide the side step molding towards the front of the vehicle and remove clips B from the molding.
    Fig 2: Removing Clips B From Molding
    G03645465Courtesy of MAZDA MOTORS CORP.
  4. Remove the side step molding.
  5. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals