LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 384 (Exterior Trim) >> Rear Finisher Removal/Installation

Rear Finisher Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trunk lid trim. (Sedan)
  2. Remove the liftgate upper trim, liftgate side trim and liftgate lower trim. (5-Door, Sport Wagon)
  3. Remove the nuts.
  4. Pull the rear finisher outward, then disengage clip A from the body.
  5. Install in the reverse order of removal.
    Fig 1: Removing/Installing Rear Finisher (Torque Specs)
    G03645470Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals