Key Replacement Or Addition (Customer Supplied 2 Or More Valid Keys)
WARNING: This page is about a different car, the 2002 Mazda 626 and 2001 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- Cut new transponder equipped key(s). Using first key, turn ignition switch to ON position, then to LOCK position 5 times. Turn first key to ON position. SECURITY light should illuminate. Turn first key to LOCK position. SECURITY light should go out.
- Using second key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn second key to LOCK position and remove key.
- Repeat step 2 with first key. Repeat step 2 with new key. Repeat step 2 with each new or valid key, up to 8 keys total. After 30 seconds, program will quit automatically.