LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Automatic Transaxle [Service, Removal & Installation Aw6A-El)) >> Transaxle Fluid Temperature (TFT) Sensor Inspection >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.
  • Do not damage the terminals.
  1. Disconnect the negative battery cable.
  2. Remove the air cleaner component. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
  3. Remove the TCM. (See TCM REMOVAL/INSTALLATION .)
  4. Verify that there is no continuity between coupler component terminals B7 and GND, or B8 and GND.
    • If there is any malfunction, perform an off-vehicle inspection of TFT sensor. (See OFF-VEHICLE INSPECTION .)
    Fig 1: TCM Connector Terminal Identification
    G03644781Courtesy of MAZDA MOTORS CORP.
  5. Install the TCM. (See TCM REMOVAL/INSTALLATION .)
  6. Install the air cleaner component. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
  7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals