LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Automatic Transaxle [Service, Removal & Installation Aw6A-El)) >> Automatic Transaxle Removal/Installation >> Selector Cable Installation Note

Selector Cable Installation Note

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the selector lever to the manual shaft lever so that no load acts on the selector cable.
    NOTE:
    • Install the selector lever to the manual shaft lever with the clip side of the selector cable end facing up.
    Fig 1: Installing Selector Lever
    G03644832Courtesy of MAZDA MOTORS CORP.
  2. Confirm that the tip of the manual shaft lever projects out of the end of the selector cable.
scientia non olet · About LEMON Manuals