Oil Pressure Switch Removal/Installation
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before changing the ATF.
- Disconnect the negative battery cable.
- Remove the under cover.
- Disconnect the cord assembly connector.
- Remove the oil pressure switch.
- Install the oil pressure switch.
Tightening torque
17.1-22.1 N.m {1.8-2.2 kgf.m, 12.7-16.2 ft.lbf}
- Connect the oil pressure switch connector.
- Install the under cover.
- Connect the negative battery cable.