LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 368 (Automatic Transaxle [Service, Removal & Installation FN4A-El)) >> Oil Cooler Removal/Installation >> Notes

Oil Cooler Removal/Installation: Notes

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Drain the ATF into a container. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT .)
  3. Remove the radiator. (See RADIATOR REMOVAL/INSTALLATION .)
  4. Remove in the order indicated in the table.
    Fig 1: Oil Cooler Removal Sequence (Torque Specs)
    G03644757Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
  6. Add ATF to the specified level. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT .)
  7. Connect the negative battery cable.
  8. Inspect for oil leakage from the oil pipes and oil hoses.
  9. Inspect for coolant from the hoses.
  10. Inspect the ATF level and condition. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT .)
  11. Carry out the line pressure test. (See MECHANICAL SYSTEM TEST .)
  12. Carry out the road test. (See ROAD TEST .)
scientia non olet · About LEMON Manuals