LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 368 (Automatic Transaxle [Service, Removal & Installation FN4A-El)) >> Mechanical System Test >> Stall Test >> Notes

Stall Test: Notes

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform mechanical system test preparation. (See MECHANICAL SYSTEM TEST PREPARATION .)
  2. Start the engine and shift the selector lever to R position.
    CAUTION:
    • Do not maintain WOT in any position/range for more than 5 seconds, or transaxle damage will occur.
  3. Firmly depress the brake pedal with the left foot, and depress the accelerator pedal to floor (WOT) with the right.
  4. When the engine speed no longer increases, quickly read the engine speed and release the accelerator pedal.
  5. Shift the selector lever to N position and let the engine idle for 1 minute  or more to cool the ATF.
  6. Perform stall tests of D, M (1GR, 2GR) ranges in the same manner.
  7. Turn off the engine.
scientia non olet · About LEMON Manuals